RF-TVMUC01_10-0665 QSG _V3_EN_final press.pdf
1
8/4/2010 2:01:50 PM
QUICK SETUP GUIDE
1: Install the locking screw
3: Install the under cabinet mount
RF-TVMUC01
Screw the TV bracket locking screw (E)into the TV bracket (A) using the
hex key (F). Do not screw in more than three or four turns.
Note: Cabinet thickness must not be less than 7/16 in.
a. Use the ceiling plate of the under cabinet mount (B) as a template to mark the hole locations.
b. Drill holes through the bottom of the cabinet using a 1/4”drill bit.
c. Tap the three 3-prongT-nuts (I) into the holes in the upper surface of the cabinet. Be careful not to
damage cabinet surface.
d. Attach the under cabinet mount (B) to the bottom surface of the cabinet using the
three cabinet mounting screws.
Thank you for choosing the
Rocketꢀsh RF-TVMUC01.
The RF-TVMUC01 TV mount
is designed to support
a TV weighing up to
A
a
35 lbs. (15.9 kg).
E
F
B
Package contents
A TV bracket (1)
B
D
A
b
B Under cabinet mount (1)
C Plate cover (1)
D Cable cover (1)
2: Attach the TV bracket
Locking hardware
E TV bracket screw (1)
F 5/32 in. hex key (1)
Attach the TV bracket (A) to the back of the TV using the four screws (G).
M4 bag
c
G M4 x 12 mm screws (4)
Mounting hardware
C
H Cabinet mount screws (3)
10-24 x 5/8 in. phillips ꢁat head screws
I
I
3 prongT-nuts (3)
Wire ties
J
8 in. Black WireTies (3)
Locking hardware
E
d
F
M4 bag
G
H
5/32 in.
M4 x 12 mm
Wire ties
Mounting hardware
H
G
I
J
A
B
10-24 x 5/8 in.
• Pencil
• Phillips screwdriver
• Hammer
• ¼ in. wood drill bit
• Power drill
Tools you will need:
|